I believe in Beta 2 using Presto it would show render passes while it was rendering. However in Beta 3 i dont see that info no more.
Perhaps this is due to when using low numbers. The update rate is way to low and still sluggish and hardly working in combination with the darkroom properties. I takes what feels like minutes to see your updates, its impossible to use like this
Also it shows very limited info while its rendering. It only show all info once it stops, dont understand that logic though.
Everything related to Altair Inspire Render beta
3 posts • Page 1 of 1
- Posts: 15254
- Joined: Tue May 12, 2009 12:42 am
- Location: Curacao, Netherland Antilles
- Has thanked: 31 times
- Been thanked: 272 times
I guess because the slow update rate, samples up to 10 and below wont show. Thats why it didnt show anything. It takes to long to show anything. Same as that the user hardly will see his adjustments in the darkroom while its rendering. Thats not really useful.